The most important point of using the 105 1.2 16 cutting disc is that it is installed, installed, and it will work more efficiently. However, if the installation is not good, it will have an impact on its use. So what are the effects of poor installation? Let's take a look at it.
1. Shock: This is because when the cutting piece is running at high speed, the vibration is severe when the handle is held, the cutting efficiency is lowered, and waste is caused. The reason is caused by the imbalance of the cutting piece.
2, bridge: it is a film. When the cutting piece is running at high speed, the trajectory cannot be straight, and the direct result is that the material after cutting has a slanting flaw, which may not meet the processing requirements.
3, it will crack, broken: This is due to the inferior quality of the mesh, the amount of binder is too small or expired, the temperature of the furnace is too low, etc., causing cracks in the cutting piece during high-speed operation, and crushing injury in severe cases. people.